Pressing out and attaching follower joint at steering knuckle - AR33.20-P-0500-01SX
MODIFICATION NOTES
| 12.10.09 | Value changed: Self-locking nut for upper ball joint on upper transverse control arm to steering knuckle, 1st stage | Model 221 with code Z07/Z07+Z19 | *BA33.20-P-1007-01M |
WHEEL LOCATION, HUB
| Number | Designation | Model 216 without 4MATIC | Model 216 with 4MATIC | ||
|---|---|---|---|---|---|
| BA33.20-P-1007-01M | Self-locking nut, upper wishbone follower joint to steering knuckle | Stage 1 | Nm | 20 | 20 |
| Stage 2 | ∠° | 90 | 90 |
WHEEL LOCATION, HUB
| Number | Designation | Model 221.00/02/05/07/09/10/12/15/17/19 without 4MATIC without code Z07/Z07+Z19 |
Model 221.09/19 without 4MATIC without code Z07 |
||
|---|---|---|---|---|---|
| BA33.20-P-1007-01M | Self-locking nut, upper wishbone follower joint to steering knuckle | Stage 1 | Nm | 20 | 20 |
| Stage 2 | ∠° | 90 | 90 |
WHEEL LOCATION, HUB
| Number | Designation | Model 221.08/09/18/19 with 4MATIC without code Z07 |
Model 221 with code Z07/Z07+Z19 | ||
|---|---|---|---|---|---|
| BA33.20-P-1007-01M | Self-locking nut, upper wishbone follower joint to steering knuckle | Stage 1 | Nm | 20 | 50 |
| Stage 2 | ∠° | 90 | 60 |
Puller 221 589 00 33 00,
thrust piece 129 589 10 63 00 and
press 163 589 03 43 00 required for vehicles with code (Z07) Top protection.
Puller 140 589 00 33 00 and
thrust piece 210 589 04 63 00 are required for vehicles without top protection.
Pushing off
- Unscrew self-locking nut from follower joint (8).
Screw the thrust washer (043a) onto the support joint (8).
- Press off the follower joint (8)
Do not damage rubber boot and stainless steel ring, as otherwise the upper transverse control arm has to be replaced.
Shown on vehicle without top protection
Mount
- Clean tapered connection.
- Replace self-locking nut and tighten.