Correct oil level in air conditioning system in the event of repair or slow refrigerant loss - AR83.30-P-5251PB

MODEL 204, 207, 212, 216, 218, 221

	Drain
	Risk of explosion caused by welding or soldering work on closed air conditioning system. Risk of poisoning caused by inhaling overheated refrigerant vapors. Risk of injury to skin and eyes caused by contact with liquid refrigerant.	Never perform welding work on or near a closed air conditioning system. No smoking or open flames. Wear safety glasses and protective gloves. Work only in well ventilated areas. Carry out repair work on the air conditioning system circuit only after the system has been drained.	AS83.00-Z-0001-01A
	Procedure for a damaged or leaky air conditioning system		AH83.30-N-0004-01A
	Protect air conditioning circuit and components from moisture when carrying out repair work	All models with air conditioning	AH83.30-N-0005-01A
	Notes on handling R134a refrigerant	All models with R134a refrigerant	AH83.30-N-0003-01A
1	Connect air conditioning service unit and drain air conditioning system (recycling)	Air conditioner service unit
	Measure
2	Determine refrigerant loss	Compare quantity of refrigerant evacuated with specified refrigerant capacity Capacity of refrigerant Model 204, 207, 212, 218	*BF83.00-P-1001-01I
		Model 216, 221	*BF83.00-P-1001-01H
	Checking
3	Check air conditioning system for leakage	System drained. In event of leakage, see: ↓	AR83.30-P-1761PS
		Replace defective component. Installation : Each time the refrigerant circuit is opened, the desiccant cartridge or fluid reservoir must be replaced, see ↓ Remove/install desiccant cartridge:
		Remove/install fluid reservoir Model 216.3, 221.0/1	AR83.30-P-6520SX
	Fill
4	Evacuating, filling air conditioning system	When charging air conditioning system, add new oil to refrigerant circuit in the amount equal to the quantity of oil extracted. Observe additional oil filling quantity after replacing parts, see: ↓ Correct oil level in air conditioning system after replacing parts.	AR83.30-P-5252PB
		Model 216, 221 Refrigerant filling capacity:	*BF83.55-P-1009-01H
		Model 216, 221	*BF83.00-P-1001-01H
	Checking
5	Check air conditioning system for leakage	System filled	AR83.30-P-1761UV

AIR CONDITIONING SYSTEM/AUTOMATIC AIR CONDITIONING

Number	Designation			Model 216	Model 221 without air conditioning in rear (code 582)
BF83.00-P-1001-01H	Filling capacity air conditioning system/automatic air conditioning	Refrigerant R134a	g	1070	1070
		Specifications for Operating Fluids	Sheet	BB00.40-P-0361-00A	BB00.40-P-0361-00A

REFRIGERANT COMPRESSOR

Number	Designation			Refrigerant compressor in model 216
BF83.55-P-1009-01H	Additional oil filling capacity in case of detectable leakage	Compressor oil	cm³	20
		Specifications for Operating Fluids	Sheet	BB00.40-P-0362-00A