Removal of centering sleeve - AR41.10-P-0200-02SX

Before removing the centering sleeve, measure and note the press-in dimension "a".
Depending on the version of flexible disk (for example, on vehicles with vibration damper) it may lead to a deviation between the measured and the specified press-in dimension "a". Then the measured press-in dimension "a" is to be taken into account before removal.

Fig 1: Identifying Press-In Dimension
Courtesy of MERCEDES-BENZ USA
Knock centering sleeve evenly out of propeller shaft (arrow) using a flat chisel.

Fig 2: Removing Centering Sleeve Evenly Out Of Propeller Shaft Using Flat Chisel
Courtesy of MERCEDES-BENZ USA

If the centering sleeve cannot be knocked out using the chisel:
Drill a hole (dia. 10 mm) 15 mm from the end face of the centering sleeve (10) at right-angles through the centering sleeve.

Fig 3: Drilling Hole From End Face Of Centering Sleeve At Right-Angles Through Centering Sleeve
Courtesy of MERCEDES-BENZ USA
Insert a drift through the hole and lever the centering sleeve (10) out of the propeller shaft using two assembly levers.

Fig 4: Inserting Drift Through Hole And Lever Centering Sleeve Out Of Propeller Shaft Using Two Assembly Levers
Courtesy of MERCEDES-BENZ USA