Install and weld in longitudinal member front section - AR62.20-P-1260-07SX
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation |
|---|---|
| WH58.30-Z-1003-02A | Clamping pliers |
| WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm |
| WH58.30-Z-1024-04A | Abrasive disk, dia. 115 mm, 80 m/s (max. 13, 250 rpm) |
WORKSHOP EQUIPMENT
| WE58.40-Z-1001-02A | Inert gas welder |
| WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
| WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
| WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
The following operation steps are shown on model 221 on the left side of the vehicle and must be performed analogously on the right side in the event of damage.
- Install longitudinal member front section (1), fit with straightening tool (2) and attach with
clamping pliers.
- Weld in longitudinal member front section (1) with
(areas A and B).
- Clean welds using
- Grind longitudinal member front section (1) down flat in cross-hatched.
- Restore and smooth surface on longitudinal member front section (1).
- Remove sanding dust using wet/dry vacuum cleaner.