Covering when painting longitudinal member - AR98.00-P-0200-13SX

Work procedure shown on model 221 

1. Remove outer longitudinal member trim (1).
2. Mask body bead of longitudinal member with overlapping adhesive tape.
3. Stick overlapping adhesive tape to the adjacent surfaces.
4. Mask front fender and rear fender with masking paper.
   Fig 1: Identifying Masked Outer Longitudinal Member Trim Body Bead

   Courtesy of MERCEDES-BENZ USA
5. Completely cover vehicle with masking paper.

   Avoid paint mist in the vehicle interior to prevent damage to the interior equipment.

   Fig 2: Identifying Vehicle Covered Area With Masked Outer Longitudinal Member

   Courtesy of MERCEDES-BENZ USA