Remove/install wiper motor - AR82.30-P-6800SX

MODEL 216.3, 221.0 /1

Illustrated on model 221

Fig 1: Identifying Wiper Motor Remove/Install Components

G07543636

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove wiper arms		AR82.30-P-6100SX
2	Unclip water collector (1)	Installation : Ensure that gaskets (2) seat properly.
3	Unscrew nuts (3) from master wiper motor (M6/6) and slave wiper motor (M6/7)		*BA82.30-P-1002-01L
4.1	Loosen bolt (4) and unscrew by a few threads	Model 216 Installation : Ensure that bolt washer (4) is seated correctly
4.1	Loosen bolt (4) and unscrew by a few threads		*BA82.30-P-1002-01L
4.2	Unscrew bolt (4)	Model 221
4.2	Unscrew bolt (4)		*BA82.30-P-1002-01L
5	Lift master wiper motor (M6/6) or slave wiper motor (M6/7) until the electrical connector on the master wiper motor (M6/6) or slave wiper motor (M6/7) is accessible
6	Detach electrical connector and remove master wiper motor (M6/6) or slave wiper motor (M6/7)
7	Install in the reverse order

WINDSHIELD WIPER

Number	Designation		Model 216	Model 221.0/1
BA82.30-P-1002-01L	Nut/screw for wiper motor to body	Nm	20	20