Pull inner bearing race off rear-axle shaft flange - AR35.20-P-0130-02TX

Fig 1: Identifying Puller (001 589 50 33 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Chuck (211 589 02 34 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Thrust Piece (124 589 02 34 00)

Courtesy of MERCEDES-BENZ USA

1. Clamp rear axle shaft flange (1) in vise.
2. Pry protective ring (3) off bearing inner race (2).
3. Mount thrust piece (04) on rear axle shaft flange (1).
   Fig 4: Identifying Protective Ring, Bearing Inner Race, Rear Axle Shaft Flange And Thrust Piece

   Courtesy of MERCEDES-BENZ USA
4. Screw collet (02) onto puller (01) and tighten.
5. Mount puller (01) onto bearing inner race and clamp securely into place.
6. Screw in thrust spindle (03) and pull bearing inner race off rear axle shaft flange (1) using puller (01).
   Fig 5: Pulling Bearing Inner Race Off Rear Axle Shaft Flange Using Puller

   Courtesy of MERCEDES-BENZ USA