Disconnect electrical connectors at rear axle - AR35.10-P-0010-02SX
- Detach fender liners in left and right rear fender and fold to one side.
- Press catch on hub (1) in left rear wheel house towards the arrow and
- remove connector (2) of left rear RPM sensor
- and connector (3) of left rear axle damping valve unit (vehicles with AIRmatic only)
from hub (1).
- Unclip electrical feed lines from wiring (4).
- Press catch on hub (5) in right rear wheelhouse towards the arrow and
- remove connector (6) of right rear RPM sensor
- and connector (7) of right rear axle damping valve unit (vehicles with AIRmatic only)
- and connector (8) of right rear brake pad contact sensor
from hub (5).
- Unclip electrical feed lines from wiring (9).