Remove/install backup camera - AR54.65-P-0030SX

MODEL 216.3, 221.0 /1 with CODE (218) Backup camera 

Shown on model 221 

Fig 1: Identifying Backup Camera Related Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Shown on model 221 

Fig 2: Identifying Backup Camera Related Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove license plate from trunk lid (1)
2	Remove umbrella holder (3)
3	Remove hazard warning triangle (5) and detach bracket (4)
4	Remove cover (6)
5	Remove hinge bracket trim pieces (2)
6	Remove trunk lid paneling (7)
7	Pull backup camera connector (B84/3x1) out of protective sleeve (8) and separate	Installation:  Position backup camera connector (B84/3x1) with protective sleeve (8) free from chafing.
8	Remove bolts (9)
9	Unclip handle strip cover (13) from inside, starting at the right-hand side of the	Installation:  Model 221 check adhesive tape (12) and replace if necessary.
10	Unclip backup camera (B84/3) from the trunk lid (1)
11	Install in the reverse order
12	Calibrate backup camera (B84/3)	Vehicle up to 31.5.07 or with code (498) Japan version If only the backup camera (B84/3) was removed, the steering angle sensor does not have to be calibrated.	AR54.65-P-0022SX