Processing permanent underbody protection agent for painting - AR97.20-P-0500-03SX
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1001-05A | Underfloor protection 800 ml | A 001 986 46 10 |
- Dark-gray permanent underfloor protection (synthetic rubber)
The permanent underfloor protection has a synthetic rubber base and is suitable for application to fender bottom parts, underbody as well as transitions to underfloor protection processed at the factory
- Permanent underfloor protection (water-base dispersion), gray
The permanent underfloor protection is a water-thinnable dispersion suitable for application to the underbody, fender bottom sections and exterior surface.
For processing on the outer surface (e. g. front fender below bumper or longitudinal members at entrance), thin material with 5 % water to achieve better coverage.
The permanent underfloor protection is not suited for sealing work (seam sealant).
Observe the following procedure when processing:
- All areas to which permanent underfloor protection is to be applied must be thoroughly cleaned (steam cleaner). In particular, remove wax and oil residues as well as loose pieces of PVC thoroughly. Grind corroded points down to bare metal and prime.
A hot air blower and flat nozzle with integrated scraper or rotating wire brushes are suitable for removing the PVC material.
- Apply permanent underfloor protection uniformly with spray gun.
Do not spray permanent underfloor protection on major assemblies; otherwise, function impairment is possible. Blow out spray gun with solvent after use. Expose air hole on screw-in thread to prevent spraying gun from sticking.
- Maintain drying time (paintable).