Rear suspension-control module - Operation check - AR32.30-P-0520A

MODEL 140, 210 with CODE (217a) Self-levelling suspension on rear axle with ADS with CODE (480) Level control system at rear 

MODEL 202, 203.2, 208 with CODE (480) Level control system at rear 

Fig 1: Identifying Rear Suspension-Control Module - Operation Check (1 Of 2)

Fig 2: Identifying Rear Suspension-Control Module - Operation Check (2 Of 2)

	Removing, installing
	The vehicle must be parked with its weight on its wheels
1	Check fluid level in reservoir, correct as indicated	Model Series 140, 202, 203.2, 208	AP32.30-P-3211BA
		Model 210	AP32.30-P-3211BB
2.1	Remove linkage rod or relay linkage (7) from suspension-control module lever (arrows)
2.2	Remove linkage rod for suspension-control module/torsion bar at ball joint	Model 203.2
	Risk of accident  from vehicle starting off by itself when engine running. Risk of injury  from contusions and burns if you insert your hands into the engine when it is started or when it is running	Secure vehicle to prevent it from moving off by itself. Wear closed and close-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
3	Start engine and allow to idle
	Inspecting
4	Press suspension-control module lever to position "fill" (F)	Because the pressures are considerable, keep test as brief as possible. The rear of the vehicle should rise. The suspension-control module's bypass valve limits the supply pressure of the hydraulic pump. The bypass valve emits a whistling noise as it opens. If the rear of the vehicle fails to rise within approximately 30 seconds ↓ Model Series 140, 202, 203.2, 208 Disconnect return line (T) from reservoir (2), if fluid emerges ↓
		Replace rear axle level controller	AR32.30-P-0670A
		Model 210 Checking hydraulic pump	AR32.30-P-0510A
		If supply rate is within specification, but pressure is too low ↓ Replace rear axle level controller	AR32.30-P-0670A
		Model Series 140, 202, 203.2, 208 If no fluid emerges from the return line Check hydraulic pump	AR32.30-P-0510A
5	Set level controller lever to "Empty" position (L)
6	Switch off engine
	Installing
7.1	Connect linkage rod or relay linkage (7) to suspension-control module lever (arrows)	Models 140, 202, 208, 210 Replace self-locking bolts and nuts.
7.2	Connect linkage rod for suspension-control module/torsion bar at ball joint	Model 203.2
8	Check fluid level in reservoir, correct as indicated	Models 140, 202, 208	AP32.30-P-3211BA
		Model 210	AP32.30-P-3211BB