 |
Risk of death
due to the vehicle slipping off or toppling off the lifting platform |
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. |
AS00.00-Z-0010-01A |
 Installation |
Replace self-locking nuts |
|
|
| 1 |
Remove spring link (6) at wheel carrier (7) |
When tightening nuts, move rear axle shaft to approximately horizontal position.
Replace self-locking nut. *BA35.20-P-1002-01A |
|
| 2 |
Press wheel carrier (7) up out of spring link (6) |
Installation:
Do not damage the boots on the supporting joint when inserting into the spring link. |
|
| 3 |
Remove supporting joint (7a) at wheel carrier |
|
AR35.20-P-0116-01B |
| |
|
 |
Figure |
| 4 |
Install in the reverse order |
|
|