Pull bearing inner race off rear axle shaft flange - AR35.20-P-0130-02A

Special tool assignment:

Models 129, 140, 163, 170, 202, 203, 208, 209, 210, 215, 220: 

Thrust piece 124 589 02 34 00,

Puller 001 589 50 33 00

Model 140, 163, 215, 220: 

Clamping pliers 140 589 01 34 00

Model 129, 170, 202, 203, 208, 209, 210: 

Clamping pliers 201 589 00 34 00

1. Screw clamping pliers onto puller and tighten.
2. Clamp rear axle shaft flange in vise with aluminum jaws.
3. Fit thrust piece (010e)with large diameter on rear axle shaft flange.
   Fig 5: Identifying Thrust Piece On Rear Axle Shaft Flange

   
4. Slip fully assembled puller over bearing inner race.

   At the upper grooves, clamp the clamping pliers over the conical sleeve of the puller.

5. Pull inner bearing race off rear axle shaft flange using puller and remove.