Install front differential mount; Front rear axle center assembly mounting modified; Front rear axle center assembly mounting modified - AR35.10-P-0050-01A

Model 129.060/061/066 

Model 202.018/022/ 028/120/121/125 

AR35.10-P-0050-01A	Install front differential mount
	Front rear axle center assembly mounting modified	Model 129.060/061/066	BT35.31-P-0001-01A
	Front rear axle center assembly mounting modified	Model 202.018/022/ 028/120/121/125	BT35.31-P-0001-01B

Number	Designation		Model 129	Model 140	Model 170
BA35.10-P-1003-01A	Self-locking nut, rear axle differential at front to rear axle carrier	Nm	45	45	50

Number	Designation		Model 202	Model 203	Model 208
BA35.10-P-1003-01A	Self-locking nut, rear axle differential at front to rear axle carrier	Nm	50	45	50

Number	Designation		Model 209	Model 210
BA35.10-P-1003-01A	Self-locking nut, rear axle differential at front to rear axle carrier	Nm	43	45

Illustrated on model 140 

1. Mount rubber bushing (60b) and short plate with 14 mm height (60a) above in the rear axle carrier (1).
2. Mount rubber bushing with guide collar (60c) and long plate with 17 mm height (60d) below, pay attention to proper seating of bearing.
3. Install appropriate shim (60e) between plate (60d) and rear axle center assembly (50).
4. Replace self-locking hexagon nut (52), install rear axle center assembly (50) at rear axle carrier (1).
   Fig 1: Identifying Rubber Bushing And Associated Components On Rear Axle Mount - Illustrated On Model 140

   

Installation for model 129 

On vehicles with automatic transmission up to approx. 08/89 install short plate with 14 mm height (60a) above and long plate with 17 mm height (60d) below.

On vehicles with automatic transmission as of 09/89 and on vehicles with manual transmission, both plates (60a, 60d) have a height of 15 mm.

Install appropriate shim (60e with notches) at rear axle center assembly (50).

Installation, model 170, 202, 203, 208, 209 

Replace self-locking hexagon nut or plate with integrated locking nut (60a).

1 or 2 shims (60e) can be installed for the rear axle center assembly depending on the version.

Shows model 210