LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2007 >> C350 Base, Automatic >> Repair and Diagnosis >> Body & Frame >> Mirrors >> Detachable Body Components -- 203 Chassis >> Retrofitting & Conversion >> Retrofitting trunk lid emergency release - AZ88.50-P-0002PD

Retrofitting trunk lid emergency release - AZ88.50-P-0002PD

MODEL 203.0 with CODE (491) U.S. version 

Fig 1: Identifying Trunk Lid Emergency Release Components
G04737607
Fig 2: Identifying Trunk Lid Contact Switch
G04737608
IMPORTANT The electric trunk lid emergency release does not operate when: 
  • the battery is disconnected or discharged
If battery is removed/disconnected (e.g.: vehicle taken out of service temporarily) it is necessary to take off the striker eye.  
IMPORTANT The function "Lock trunk lid separately" (90° position of trunk lid lock) is no longer present after the trunk lid emergency release is installed.    
IMPORTANT Check trunk lid remote opening feature for proper operation    
IMPORTANT On vehicles as of end no. F059 804  it is only necessary to install the trunk interior pushbutton  and deactivate the 90° position trunk lid lock     
REMOVING Removing     
1 Disconnect ground cable of battery IMPORTANT up to end no. F059 803  
REFER TO TESTING & REPAIR     AR54.10-P-0003P
2 Remove trunk lid paneling and cable duct    
3 Remove trunk lid contact switch (S88/6) at trunk lid lock and tie back connector with electric cable IMPORTANT The function "Lock trunk lid separately" (90° position of trunk lid lock) is then no longer available.  
4 Remove paneling of trunk floor and side paneling on left in trunk    
REFER TO TESTING & REPAIR Remove paneling in trunk   AR68.30-P-4600P
5 Check rear SAM control module with fuse and relay module IMPORTANT If SAM control module with
ET no. A 203 545 07 01 or
ET no. A 002 545 97 01
(SW26/00, Q11 status)
is not fitted ↓
 
REFER TO TESTING & REPAIR   Replace rear SAM control module with fuse and relay module AR54.21-P-1259P
INSTALLING Installation     
6 Retrofitting trunk lid emergency release wiring harness IMPORTANT up to end no. F059 803 AZ88.50-P-0002-05PD 
    SPECIAL TOOL Wiring harness repair kit Figure
7 Retrofitting trunk interior button   AZ88.50-P-0002-06PD 
8 Enter fuse assignment in fuse assignment plan IMPORTANT up to end no. F059 803  
9 Fit remaining parts to vehicle IMPORTANT When installing trunk lid paneling, connect trunk interior button.  
10 Carry out operational check    
IMPORTANT Notes on electric trunk lid emergency release Models 129, 202, 203, 208, 210, 215, 220 AH88.50-P-0001-01A 
11 Place insert sheet for trunk lid emergency release in Owner's Manual IMPORTANT Order number see parts ordering notes.  
Fig 3: Identifying Wiring Harness Repair Kit (220 589 01 99 00)
G04737609
PARTS ORDERING NOTES

Part no. Designation Quantity
A 203 821 35 58 Switch 1
A 203 540 34 13 Wiring harness 1
A 002 546 74 40 Cut/clamp (SKT) connector 3
A 203 545 07 01 Fuse socket (rear SAM control module with fuse and relay module) 1
6515955813 Insert sheet for Owner's Manual, electric kit (can be ordered from printshop Storopack, Hotline telephone number: +49-7123/64242) 1