LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2007 >> C280 Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Fluids -- Capacities & Specifications -- 203 Chassis - 1 Of 2 >> Capacities & Specifications >> Specified engine oils (service) - overview - BB00.40-P-0223-02A

Specified engine oils (service) - overview - BB00.40-P-0223-02A

BB00.40-P-0223-02A  Specified engine oils (service) - overview For Mercedes-Benz and Smart Sheet 223.2
  viscosity classes Sheet 224.1 (passenger-car engines) BB00.40-P-0224-01A 
    Sheet 224.2 (commercial-vehicle engines) BB00.40-P-0224-02A
  Single-grade oils Sheet 228.0 BB00.40-P-0228-00A 
    Sheet 228.2 BB00.40-P-0228-02A 
  Multigrade oils Sheet 226.9 BB00.40-P-0226-09A 
    Sheet 228.1 BB00.40-P-0228-01A 
    Sheet 228.3 BB00.40-P-0228-03A 
    Sheet 228.31 BB00.40-P-0228-31A
    Sheet 228.5 BB00.40-P-0228-05A 
    Sheet 228.51 BB00.40-P-0228-51A 
    Sheet 229.1 BB00.40-P-0229-01A 
    Sheet 229.3 BB00.40-P-0229-03A 
    Sheet 229.31 BB00.40-P-0229-31A 
    Sheet 229.5 BB00.40-P-0229-05A 
    Sheet 229.51 BB00.40-P-0229-51A 

The temperature ranges in the viscosity classes must be observed for the use of the engine oils (see Sheets 224.1 and 224.2)!

Single-grade oils are listed on sheets: 228.0, 228.2 - only to be used in summer.

Multigrade oils are listed on sheets: 226.9, 228.1/.3/.31/.5/.51, 229.1/.3/.31/.5/.51 - use possible year round.

PASSENGER VEHICLE ENGINES, COMMERCIAL VEHICLE ENGINES FROM THE PASSENGER CAR DIVISION, INDUSTRIAL ENGINES FROM THE CAR SECTOR (SERIES 100, SERIES 600)

MB Specifications for Operating Fluids Sheet (1) 226.9 Multigrade 228.0/.1 Single/multi grade 228.2/.3 Single/ multi grade 228.31 (2) Multigrade 228.5 Multigrade 228.51 (2) Multigrade 229.1 Multigrade 229.3 Multigrade 229.31 (2) Multigrade 229.5 Multigrade 229.51 (2) Multigrade
Gasoline engines                       
M 155 (SLR) - - - - - - - (3) - - -
M 156 - - - - - - - - - (4) (4)
AMG engines except M 155 (SLR) and M 156 - - - - - - - - - (4) -
M 132 (USA) - - - - - - - - -
M 111, 137, 272, 273 - - - - - - - -
M 112, 113, 134, 135 - - - - - -
M 122, RA1 (M132 ROW) 275 - - - - - - - - -
M 160, 160/1, M 285 (Maybach) - - - - - - - - - -
M 166 - - - - - - - - -
M 266, 271 - - - - - - -
Other
M 1xx, M 2xx that are not listed above
- - - - - - - -
Diesel engines                       
without particulate filter (DPF)                       
OM 660 - - - - - - -
OM 640, 642, 646 in model series 639
OM 646, 647, 648
- - -/• - -
OM 611, 612, 613, 628, 639, 668, 664, 665 - -/◦ -/• -
Other OM 6xx not listed above - -/◦ -/• -
with particulate filter (DPF)                       
OM 629, 639, 640, 642, 646, 647, 648, 664, 665
OM 646 in model series 639 and 906
- - - - - - - -
OM 660 (EU3/EU4 not with regulated DPF) - - - - - - -
Other
OM 6xx with DPF not listed above
- - - - - - - -
(1) Sheets 227.0/.1 no longer exist! Replaced by engine oils in sheet 228.0/.1/.2/.3/.31/.5/51.
(2) Use in combination with low-sulfur (S < 50 ppm) or sulfur-free (S < 10 ppm) fuel! If fuels with sulfur contents of S> 500 ppm are being used, the oil change intervals must be reduced!
(3) Restriction: Only "Mobil 1 5W-50", SAE 5W-50, sheet 229.3 is approved!
(4) Restriction: Only engine oils SAE XW-40 may be used!
COMMERCIAL VEHICLE ENGINES, INDUSTRIAL ENGINES FROM THE COMMERCIAL VEHICLE SECTOR (BR 300, BR 400, BR 500, BR 900)

MB Specifications for Operating Fluids (1) Sheet 226.9 Multigrade 228.0/.1 Single/multigrade 228.2/.3 Single/ multigrade 228.31(2) Multigrade 228.5 Multigrade 228.51(2) Multigrade 229.1 Multigrade 229.3 Multigrade 229.31(2) Multigrade 229.5 Multigrade 229.51 (2) Multigrade
Commercial vehicles, buses without particulate filter                       
BR 300, 400, 500, 900; OM 457, 460 up to and including Euro 3 - ◦/• ◦/• - - - - -
BR 500, 900; OM 457, 460 Euro 4/5 - - ◦/• - - - - -
Gas engines - - - - - - - -
Commercial vehicles, buses with particulate filter                       
BR 500, 900; OM 457, 460 - - - - - - -
This table only serves as an overview!
The detailed maintenance and oil change regulations can be found in the maintenance booklet for the respective vehicle/ major assembly.
• Enable
◦ Can only be used in exceptional cases or under certain operating conditions/in certain applications.
- Must not be used
(1) Sheets 227.0/.1 no longer exist! Replaced by engine oils in sheet 228.0/.1/.2/.3/.31/.5/51.
(2) Use in combination with low-sulfur (S < 50 ppm) or sulfur-free (S < 10 ppm) fuel! If fuels with sulfur contents of S> 500 ppm are being used, the oil change intervals must be reduced!
3.) Restriction:  Only "Mobil 1 5W-50", SAE 5W-50, sheet 229.3 is approved!
4.) Restriction:  Only engine oils SAE XW-40 may be used!