Noise from front seat when load is changed - AF91.10-P-1102AG

MODEL 203

MODIFICATION NOTES

10.8.01

Supersedes STIP 91.10-006 dated 09.08.2001

Content updated

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Category	Op. no.	Operation text	Time	Acc. no.	Code
P	941061	WORK: ELIMINATING NOISES ON FRONT SEATS DURING LOAD CHANGE.	010 WU/0.8 h	-	-

Damage code	Cause	Remedy
91 027 36	No lubricant on inclination adjustment shaft in area of bearing bracket. Do not replace seat adjustment, only perform work on vehicle subject to complaint.	Lubricate inclination adjustment shaft and both bearing brackets on left and right with lubricant.
		For specific reasons, we would like to point out again that for eliminating noises on plastic parts such as this STIP, only use lubricant part number 000 989 36 60.
		Commercial greases contain substances which extract the softener in the plastic and cause the bearing bracket to break.
		1 Remove front seat.	AR91.10-P-1000P
		2 Place front seat down on suitable surface with bottom pointing up.
		3 Press out plastic pins on bearing brackets on left and right and remove bearing bracket (clipped in). Bearing bracket and plastic pins may be used only once.
		4 Apply lubricant in contact area between bearing bracket and inclination adjustment shaft. For lubricant see parts ordering notes
		5 Install in reverse sequence.

PARTS ORDERING NOTES

Part no.	Designation	Quantity
203 912 00 41	Bow	2
203 918 00 14	Pin	4
000 989 36 60	Lubricant	As required