Fuel injection and ignition system (ME-SFI ) diagnosis diagnostic trouble code memory (Fault Codes P0700, P0702, P0715, P0720, P0730, P0740, P0743, P0748, P0753, P0758, P0763, P0801, P0803, P0805, P0806, P0809, P0811, P1163, P1181, P1182, P1186, P1235, P1236, P1386, P1400, P1420, P1453, P1491, P1519, P1525, P1542, P1551, P1570, P1580, P1584, P1603P, P1605, P1642, P1643, P1644, P1681, P1747) - AD07.61-P-4000DA
ENGINES 111.921 /942 as of 1.9.98, 111.943, 111.944 as of 1.8.96, 111.946 as of 1.6.98, 111.947 /973, 111.975 as of 1.8.96 fault codes P0700 to P1747
ENGINE 111.945 in MODELS 208.335 /435 as of 1.6.98, 202.020 /080 as of 1.9.98 fault codes P0700 to P1747
ENGINE 111.974 with CODE (494a) USA version with CODE (807) Model year 1997 with CODE (808) Model year 1998 fault codes P0700 to P1747
| Hazard from contact with parts conducting high voltages. | Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out work on the ignition system. | AS15.10-Z-0001-01A | |
| Lethal hazard from being drawn into rotating vehicle parts | Do not reach into rotating parts. Wear closed and close-fitting work clothes. Secure area of rotating vehicle components against unauthorized access. |
AS00.00-Z-0004-01A | |
| Risk of explosion from fuel igniting, risk of poisoning from inhaling and swallowing fuel as well as risk of injury to eyes and skin from contact with fuel. | No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| Fuel injection and ignition system (ME-SFI ) diagnosis contents Check and adjust engine |
M111.943/946 as of 6/98, M111.973 in model 170. M111.944 as of 8/96 in model 202, M111.974 in model 202 M111.975 as of 8/96 in model 202.024, M111.975 in model 202.085. M111.944/975 in model 208, M111.945 as of 6/98 in model 208.335, M111.945 in model 208.435. M111.947 in model 210 |
AD07.61-P-1000WZ Engine diagnosis manual, index B |
|
| Fuel injection and ignition system (ME-SFI ) diagnosis previous knowledge | AD07.61-P-2000D | ||
| Fault code cannot be read out with pulse counter | |||
| ■ Symbol for exhaust-related faults that lead to actuation of CHECK ENGINE malfunction indicator lamp in USA vehicles. Lamp is not actuated until tests have been performed and faults have been detected | |||
| a | Connect hand-held tester (HHT), read out diagnostic trouble code memory | Models 124.034/036, models 129.058/063/067/076 Models 140, 170, 202, 208, 210 Model 124 except 124.034/036, Models 129.060/061/066, model 201 |
AD00.00-P-2000-03A AD00.00-P-2000-03B |
| b | Ignition ON | ||
| Diagnostic trouble code memory: | |||
| Error code |
Possible cause | Note | Remedy |
| No fault recognized | Depending on nature of complaint, perform full ME-SFI electrical test | AD07.61-P-6000D AD07.61-P-6001D AD07.61-P-6002D AD07.61-P-6003C AD07.61-P-6004A |
|
| P0700 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0702 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0715 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0720 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0730 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0740 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0743 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0748 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0753 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0758 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0763 ■ | Read out ETC control module diagnostic trouble code memory (N15/3) | AD27.19-P-1000AZ | |
| P0801 | Engine and AC electric suction fan (M4/3) | CODE (580) air conditioning or with |
AD07.61-P-6000-36B |
| P0803 | Recirculated air flap actuator (M16/7) for compressor (causal chain, measured using air mass) | Compressor | AD07.61-P-6000-55A |
| P0805 | Recirculated air flap actuator (M16/7) output stage | Compressor | AD07.61-P-6000-53A |
| P0806 | Magnetic compressor clutch (Y2/1) | Compressor | AD07.61-P-6000-54A |
| P0809 | Camshaft to crankshaft angle difference | Inspect basic position of camshafts | |
| P0811 | CAN from EIS | AD07.61-P-6000-34C | |
| P1163 | Oil level indicator switch (S43) | AD07.61-P-6000-49A | |
| P1181 | Engine/AC electrical suction-type fan (M4/3) malfunction | CODE (580) air conditioning or with |
AD07.61-P-6000-36B |
| P1182 | Starter relay N65 k2 Starter relay K40/4 k2 |
Models 170, 208 Model 202 as of 1.6.97 Model 210 as of 1.6.98 |
AD07.61-P-6000-03D |
| P1186 | Safety fuel shut-off detected | AD07.61-P-6002-03B AD07.61-P-6002-04A Throttle valve actuator sluggish/sticking Check intake for residue |
|
| P1235 | Recirculated air flap actuator (M16/7) output stage | Compressor | AD07.61-P-6000-53A |
| P1236 | Magnetic compressor clutch (Y2/1) | Compressor | AD07.61-P-6000-54A |
| P1386 | ME-SFI control module (N3/10) anti-knock control at control limit | Increased tendency to knock caused by bad fuel, coked-up combustion chambers or mechanical damage ME-SFI control module (N3/10) |
|
| P1400 ■ | EGR switchover valve (Y27) | 111.974 |
AD07.61-P-6000-50A |
| P1420 ■ | Air pump changeover valve (Y32) | Model 202 Model 170 |
AD07.61-P-6000-25C |
| P1453 ■ | Air pump relay in fuse and relay module (K40/4) | 111.974 with CODE (807) model year 1997 with CODE (808) model year 1998 |
AD07.61-P-6000-24D |
| P1491 | Refrigerant pressure in AC system too high | Check AC system | |
| P1519 ■ | Camshaft timing (causal chain) | AD07.61-P-6000-47A | |
| P1525 ■ | Camshaft timing solenoid (Y49) | AD07.61-P-6000-46A | |
| P1542 | Pedal value sensor (B37) | AD07.61-P-6002-08A AD07.61-P-6002-09A |
|
| P1551 | AC compressor shutoff output stage | Model 170 with M111.946 as of 6/98, Model 202 with M111.921/945 as of 6/98, Model 208 with M111.945 as of 6/98, Model 210 with M111.942 as of 6/98 with CODE (580) air conditioning or |
AD07.61-P-6000-57A Wrong AC push-button control module installed |
| P1570 | A Start test performed with locked DAS B Fault in CAN from DAS control module to ME-SFI control module (N3/10) C ME-SFI control module and DAS control module are incompatible |
Incorrect operation Check DAS, diagnosis manual structure AD07.61-P-6000-34C Check control modules and part nos. |
|
| P1580 ■ | Actuator (M16/6) | AD07.61-P-6002-03B AD07.61-P-6002-04A |
|
| P1584 | Stop lamp switch | Model 210 as of 06/96 with CODE 212a | AD42.00-P-4000A |
| Model 210 as of 06/96 with CODE 471a | AD42.00-P-4000A | ||
| Model 210 as of 06/99 with CODE 472a | AD42.45-P-4000A | ||
| P1603 | CAN from EIS | AD07.61-P-6000-34C | |
| P1605 | Poor road surface detection signal (by comparing wheel speeds) | Model 210 with M111 as of 06/96 except CODE 472a Model 210 with M111 with CODE 472a |
AD42.40-P-1000AZ AD42.45-P-1000AZ |
| P1642 | ME-SFI control module coded incorrectly (coded for MT, vehicle has AT) | Check and correct variant coding | |
| P1643 | ME-SFI control module coded incorrectly (coded for AT, vehicle has MT) or no CAN transmission from ETC control module (N15/3) | Check and correct variant coding AD27.19-P-1000AZ |
|
| P1644 | Transmission variant cannot be checked because of undervoltage at ETC control module (N15/3) | AD27.19-P-1000AZ | |
| P1681 | Implausible crash signal | as of 06/98 | AD07.61-P-6000-56A |
| P1747 ■ | A CAN fault: Transmission protection malfunction from ETC control module (N15/3) B CAN fault: Instrument cluster |
AD27.19-P-1000AZ Check IC, communication diagnosis manual index 1 |