Knock sensor ME - fault code description - AD07.61-P-4000-12AA

		Knock sensors (A16/1, A16/2)
1A	Fault code	P2011 Knock sensor 1, on right (A16/1) (-)
	( Readout on generic scan tool)	P2038 Knock sensor 2, on left (A16/2) (-)
1B	Engines 112, 113 as of 1/019	P2011-[1] Right knock sensor 1 (A16/1), signal implausible/short circuit to positive (-)
	Fault code ( Readout on generic scan tool)	P2011-[2] Right knock sensor 1 (A16/1), signal implausible/short circuit to ground or line discontinuity (-)
		P2038-[1] Left knock sensor 2 (A16/2), signal implausible/short circuit to positive (-)
		P2038-[2] Left knock sensor 2 (A16/2), signal implausible/short circuit to ground or line discontinuity (-)
2	Fault storage	Fault is stored immediately
	Actuation of the engine diagnosis indicator lamp (EURO3/4) or CHECK ENGINE (MIL) malfunction indicator lamp	The malfunction indicator lamp is not actuated
3	Checking frequency	Continuous
4	Checked signal or status	Knock sensor signal (comparison value calculated in the ME-SFI control unit)
5	Fault setting conditions	The signal from the knock sensor must lie between 0.10 volts and 4.98 volts (direct voltage share). The band width of the modulated noise signal must not be smaller than 0.05 volts (calculated in the ME control unit), otherwise no noises are recognized.
6	Check prerequisites	engine at operating temperature engine speed greater than 2000 rpm load higher than 40%D knock control enabled engine not under full loading no fault in crankshaft position sensor and camshaft Hall sensor
7	0	There will be retarding of the ignition timing on all cylinders for safety reasons if a fault occurs.