| 1 |
Fault code |
P0105 |
| 2 |
Fault storage |
after the end of the test period and faults |
| |
Activation of malfunction indicator lamp for engine diagnosis (EURO3/4) or CHECK ENGINE (MIL)  |
after two successive driving cycles with faults |
| 3 |
Frequency of the test |
continuous |
| 4 |
Checked signal or status |
Limits for pressure sensor signal (intake manifold absolute pressure) |
| 5 |
Fault setting conditions |
|
| |
Lower limit |
approx. 0 mbar, if throttle valve angle is greater than 80° |
| |
Upper limit |
approx. 500 - 1200 mbar, map dependent on engine speed and throttle valve angle |
| |
Order of magnitude for lower limit |
at least -60 mbar, if engine speed < 1300 rpm |
| |
Test duration |
approx. 5 s for each limit |
| 6 |
Test prerequisites |
- blocking interval post-start of approx. 30 s elapsed
- no fault in throttle valve angle
|