ETC control unit, ME-SFI fault code description - AD07.61-P-4000-29L

1	Fault code	P205E Internal fault (variant, memory, transmission) (P0702)
	( Display on generic scan tool)	P2067 Selector lever module incorrectly coded (P0705) P2068 CAN message for rear wheel speeds from ESP control unit missing or incorrect (P0720) P20D5 The torque request from the ETC control unit is implausible. Implausible (P0702) P20D6 CAN transmission error of torque request from ETC control unit (P0702) P20D7 CAN transmission error of torque request from ETC control unit (P0702)
2	Fault storage	After expiry of test duration and fault
	Actuation of the indicator lamp
	Engine diagnosis (EURO3/4)	No actuation
	CHECK ENGINE (MIL)	Following two successive driving cycles with faults
3	Checking frequency	Continuous
4	Checked signal or status	Fault in ETC control unit CAN communication Impermissible variant coding Internal memory (RAM, ROM, EEPROM) Implausible torque request.
5		Faults are detected by the ETC control unit and sent via the CAN data bus to the ME-SFI engine control unit. Fault storage and actuation of the CHECK ENGINE (MIL) indicator lamp is carried out by the ME-SFI control unit. Also read out ETC fault memory.