Notes on electric trunk lid emergency release - AH88.50-P-0001-01A
Models 129, 202, 203, 208, 210, 215, 220
General
The trunk lid can be opened with a button in the trunk.
The following functions are used:
- CL open (SN1)
- Open trunk lid (HD-AS or S2)
When the button is actuated the two signals are switched one after another with time delay.
Firs the CL opens, then the trunk lid lock is actuated.
Button illumination:
- Color green.
- Flashing frequency approx. 1 Hz
- Switching on by opening trunk
- Switch-on duration after closing trunk approx. 60 min.
Function requirements
- The battery must be connected and charged (operating voltage range for emergency trunk release:
9V to 15.5V)
CAUTION:
When the battery is removed/disconnected (e.g.: when vehicle is shut down temporarily) remove striker eye from trunk lid lock for safety reasons.
The function "Lock trunk lid separately" (90° position for trunk lid lock) is no longer present after the trunk lid emergency release is installed
Function check
- Open trunk lid (the button illumination should flash)
- Close trunk lid lock, if required pull tappet switch (trunk lid remains open)
- Actuate trunk lid inner button when CL is closed:
- CL opens
- Trunk lid lock actuation with CL open:
- Trunk lid lock actuation
If lock is blocked actuation is repeated twice (after approx. 10 s and approx. 20 s)