Malfunctions in CD mode - AF82.64-P-6004B

MODEL 203, 463 with CODE (819) 6-disk CD changer with CODE (819) CD changer

MODIFICATION NOTES

13.8.01

Supersedes STIP 82.64-003 dated 10.08.2001

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Category	Op. no.	Operation text	Time	Acc. no.	Code
P	825707	REMOVE CD CHANGER	006 WU/0.5 hrs	-	-
P	820000	EXTENDING FIBER OPTIC CABLE	004 WU/0.3 h	-	-

Damage code	Cause	Remedy
	Only vehicles are affected which have no additional components installed in the D2B ring in addition to the radio and CD changer.	Do not remove, install or replace CD changer or radio. The manufacturer is presently working on a modification for the CD changer.
	Due to the high light intensity of the signals on the fiber optic cable, interference noises or noise can occur occasionally when playing a CD in the CD changer.	The ignition and radio must be switched off during the work.
		1 Extend length of fiber optic cable from CD changer output to radio input. White end of fiber optic cable to CD changer.
		2 Open fiber optic cable connector on CD changer.
		3 Remove fiber optic cable from connector.
		4 Insert and catch fiber optic cable in coupler.
		5 Insert and catch additional fiber optic cables in coupler as well. When ordering fiber optic cable always specify length of 200 mm!
		6 Insert and catch the open end of the additional fiber optic cable in the side of the connector still free on the CD changer.

PARTS ORDERING NOTES

Part no.	Designation	Quantity
A 000 545 33 84	Coupler	As required
A 000 540 38 08 0200	Fiber optic cable	As required