Check adjustment dimension of drive pinion - AR35.31-P-0550-18C
| Number | Designation | Model 124 | Model 129 | Model 170 | |
|---|---|---|---|---|---|
| BE35.31-P-1001-03A | Permissible deviation from specified adjustment dimension on end face of drive pinion | mm | -0.02/+0.01 | -0.02/+0.01 | -0.02/+0.01 |
| Number | Designation | Model 201 | Model 202 | Model 203 | |
|---|---|---|---|---|---|
| BE35.31-P-1001-03A | Permissible deviation from specified adjustment dimension on end face of drive pinion | mm | -0.02/+0.01 | -0.02/+0.01 | -0.02/+0.01 |
| Number | Designation | Model 208 | Model 209 | Model 210 | |
|---|---|---|---|---|---|
| BE35.31-P-1001-03A | Permissible deviation from specified adjustment dimension on end face of drive pinion | mm | -0.02/+0.01 | -0.02/+0.02 | -0.02/+0.01 |
- Position magnetic disk (052c) 126 589 00 21 00 Part 16 on end face of drive pinion (47) for measuring adjustment dimension "A".
Insert dial indicator (052a) with measuring pin into
- Press adjusting piece (052b) 126 589 00 21 00 part 10 against
Measuring pin for
- Insert measuring device (052) from left bore into rear axle housing.
When inserting
- Read off adjustment dimension "A". The adjustment dimension must be within the tolerance.
The adjustment dimension "A" is the design basic adjustment of the drive pinion, whereby the basic deviation "a" must be within the permissible tolerance in the positive (+) or negative (-) direction. The basic deviation "a" is the dimension which is indicated on the end face of the drive pinion.
If the adjustment dimension is outside the tolerance, the shim installed should be reground or a new shim of appropriate thickness should be installed. However, it is absolutely essential to use a new spacer sleeve for the tapered roller bearings.