Test values for rear axle center assembly gear set - BE35.31-P-1000-03A
Rear axle center assembly dia. mm 168, 185, 187FE, 198, 210, 210E, 211E
TEST VALUES FOR REAR AXLE CENTER ASSEMBLY GEAR SET
| Number | Designation | Model 124 | Model 129 | Model 140 | |
|---|---|---|---|---|---|
| BE35.31-P-1001-03A | Permissible deviation from specified adjustment dimension on end face of drive pinion | mm | -0.02/+0.01 | -0.02/+0.01 | -0.02/+0.01 |
| BE35.31-P-1002-03A | Gear backlash between crown wheel and pinion | mm | 0,08-0,14 | 0,08-0,14 | 0,08-0,14 |
| BE35.31-P-1003-03A | Ring gear heating temperature during installation | °C | 75-85 | 75-85 | 75-85 |
TEST VALUES FOR REAR AXLE CENTER ASSEMBLY GEAR SET
| Number | Designation | Model 170 | Model 201 | Model 202 | |
|---|---|---|---|---|---|
| BE35.31-P-1001-03A | Permissible deviation from specified adjustment dimension on end face of drive pinion | mm | -0.02/+0.01 | -0.02/+0.01 | -0.02/+0.01 |
| BE35.31-P-1002-03A | Gear backlash between crown wheel and pinion | mm | 0,08-0,14 | 0,08-0,14 | 0,08-0,14 |
| BE35.31-P-1003-03A | Ring gear heating temperature during installation | °C | 75-85 | 75-85 | 75-85 |
TEST VALUES FOR REAR AXLE CENTER ASSEMBLY GEAR SET
| Number | Designation | Model 203 | Model 208 | Model 209 | |
|---|---|---|---|---|---|
| BE35.31-P-1001-03A | Permissible deviation from specified adjustment dimension on end face of drive pinion | mm | -0.02/+0.01 | -0.02/+0.01 | -0.02/+0.02 |
| BE35.31-P-1002-03A | Gear backlash between crown wheel and pinion | mm | 0,10-0,16 | 0,08-0,14 | 0,10-0,16 |
| BE35.31-P-1003-03A | Ring gear heating temperature during installation | °C | 75-85 | 75-85 | 75-85 |
TEST VALUES FOR REAR AXLE CENTER ASSEMBLY GEAR SET
| Number | Designation | Model 210 | Model 220.063/065/067/083/084/087/165/167/183/184/187 | |
|---|---|---|---|---|
| BE35.31-P-1001-03A | Permissible deviation from specified adjustment dimension on end face of drive pinion | mm | -0.02/+0.01 | -0.02/+0.01 |
| BE35.31-P-1002-03A | Gear backlash between crown wheel and pinion | mm | 0,08-0,14 | 0,08-0,14 |
| BE35.31-P-1003-03A | Ring gear heating temperature during installation | °C | 75-85 | 75-85 |