Preparing rear longitudinal member for installation - AR64.20-P-1200-23P

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1001-03A	Round wire brush, braided, dia. 70 mm

WORKSHOP EQUIPMENT

WE58.40-Z-1001-03A

Drill (electric/pneumatic)

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1001-07A	Zinc dust paint suitable for spot welding	A 000 986 34 42

Fig 1: Identifying Rear Longitudinal Member Grinding Areas

1. Grind connection surfaces to bare metal in shaded areas. Grind spot welding flanges down to bare metal on both sides. Coat inside of spot welding flanges with zinc dust paint.