Removing and installing load compartment floor covering - AR68.20-P-4810PB

MODEL 203.2 

Fig 1: Identifying Load Compartment Floor Covering Remove/Install Components

	Removing, installing
	Protect removed parts against contamination
1	Remove rear floor covering	The floor covering can be removed by pulling the handle (arrow)
2	Unscrew both cargo retainers (3)	Screw for cargo retainer mount on load compartment floor	*BA68.50-P-1001-02A
		Screw for cargo retainer mount on D-pillars	*BA68.50-P-1002-02A
3	Lift front floor covering and remove
4	Install in the reverse order

LUGGAGE NETS

Number	Designation		Model 203.2
BA68.50-P-1001-02A	Screw for cargo retainer mount on load compartment floor	Nm	20
BA68.50-P-1002-02A	Screw for cargo retainer mount on D-pillars	Nm	20