Remove/install armrest lid on center console - AR68.20-P-2370Q

MODEL 203, 209 

with CODE (326) Telephone holder in front armrest 

with CODE (386) Preinstallation for "portable CTEL" UPCI telephone system 

MODEL 209 with CODE (494a) USA version 

Shown on model 209 

Fig 1: Identifying Armrest Lid On Center Console

Fig 2: Identifying Armrest Lid Lever, Button And Pins

Fig 3: Identifying Armrest Lid Button And Bearing Eyes

	Remove
1	Open cover (1)	Actuate button (3).
2	Press both levers (2) down	Keep both levers (2) pressed.
3	Slightly swivel lid (1)	Until button (3) extends again.
4	Press in pin (4)
5	Actuate button (5)
6	Front lid (1)
	Install
7	Press both levers (2) down	Keep both levers (2) pressed.
8	Press in pin (4)	Keep pin (4) pressed.
9	Actuate button (3)	Release both levers (2) and pin (4)
10	Release button (3).
11	Install lid (1) in bearing eyes (6)
12	Press both levers (2) down
13	Slightly swivel lid (1)	Until button (3) extends again.
14	Press both levers (2) further down	Keep both levers (2) pressed.
15	Press in pin (4)	Keep pin (4) pressed.
16	Actuate button (5)	Keep button (5) pressed.
17	Release both levers (2) and pin (4)
18	Release button (5).
19	Close lid (1)	until button (5) extends again.
	Check
20	Check lid (1) for proper function