Removing and installing C-pillar paneling - AR68.30-P-4490P

MODEL 203.0 

Illustrated for code (287a) Through-loading feature 

Fig 1: Identifying C-Pillar Paneling Remove/Install Components - Model 203.0

	Removing, installing
1.1	Remove rear seat cushion		AR91.12-P-1020P
1.2	Release rear seat cushion and fold forwards	With code (287a) Through-loading feature
2	Unscrew screw from belt end fitting (1)	Screw at belt end fitting	*BA91.40-P-1001-01A
		Torx bit set	Figure
3	Remove edge guard (4) in area of C-pillar paneling (3)
4	Remove SRS airbag cover
5	Unscrew screw (2) on C-pillar paneling (3)	External torx set	Fig 2
6	Unclip C-pillar paneling (3) at top to center of vehicle and pull out of rear shelf guide toward front
7	Remove C-pillar (3) paneling	Installation:  Observe installation position for seat belt (5)
8	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Fig 2: Identifying External Torx Set (001 589 76 09 00)

Fig 3: Identifying Torx Bit Set (000 589 01 10 00)