Sealing rear door liner - AF72.12-P-3100-01P

Fig 1: Identifying Assembly Wedge (110 589 03 59 00)

Fig 2: Identifying Torx Bit Set (000 589 01 10 00)

Remove switch strip in door liner and seal air tight with cellophane tape (1).

Fig 3: Identifying Cellophane Tape
After installing switch strip, apply self-adhesive bonding foil over large surface of door liner in area of switch strip.

Fig 4: Identifying Self-Adhesive Bonding Foil Over Large Surface Of Door Liner
Seal passage groove on door opening lever with foil seal.
Ensure that lever (arrow) remains free to move.

Fig 5: Identifying Door Opening Lever
Remove door handle and install piece of foam rubber (4) at bottom of door handle.
Position piece of foam rubber precisely with notch (see arrow).

Fig 6: Identifying Foam Rubber & Notch Position
After removing the backing foil, glue piece of foam rubber so that openings are covered (see arrows).
When the handle is installed, the piece of foam rubber is pressed against the openings sealing them completely. The piece of foam rubber must be positioned and bonded precisely to ensure complete tightness.

Fig 7: Identifying Foam Rubber On Openings

PARTS ORDERING NOTES

Part no.	Designation	Quantity
A220 682 07 08	Self-adhesive bonding foil (per door)	1
A203 737 21 30	Piece of foam rubber, left rear door	1
A203 737 22 30	Piece of foam rubber, right rear door	1
A203 682 04 31	Foil seal (self-adhesive)	as required