Remove/install paneling at front of Vario-roof - AR68.30-P-4350V

MODEL 171.4 

Fig 1: Identifying Paneling At Front Of Vario-Roof Components

Courtesy of MERCEDES-BENZ USA

	Remove/Install
	Risk of injury  from pinching  or squeezing  when working on partially open Vario roof (stop mode) or in its closing area as a result of the Vario roof suddenly collapsing	Secure Vario roof with a suitable special tool.
1	Moving Vario roof into intermediate position and securing	Position C-pillar approx. 90°.	AR77.50-P-3000-01V
			Fig 4
2	Unscrew bolts (2)
3	Unclip headliner (1) from Vario roof front section (4) in area of clips (3)	Carefully unclip headliner (1), otherwise clips (3) can break
			*WH58.30-Z-1004-19A
4	Unclip headliner (1) from catch lugs (5) and concealed catch lug (arrow) from Vario roof front section (4) using mounting wedge.	Installation:  Ensure that catch lugs (5, arrow) are seated properly in associated retaining clips on Vario roof front section (4).
			Figure
5	Remove headliner (1)	Installation:  Position left and right gasket (6) on headliner (1) with clean long wedge
			Figure
6	Install in the reverse order

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Support (230 589 04 63 00)

Courtesy of MERCEDES-BENZ USA

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1004-19A	Door panel release lever