Remove/install mount for catch on crossmember above windshield - AR77.33-P-3450V

Fig 1: Identifying Mount For Catch On Crossmember Components Above Windshield

Courtesy of MERCEDES-BENZ USA

	Removing
1	Remove paneling on left or right A-pillar	Remove A-pillar paneling only to the extent that the mount (1) is accessible.	AR68.30-P-4050V
2	Mark installation position of mount (1)
3	Unscrew nuts (2) and remove mount (1) together with spacers (3)	Observe installation location of spacers (3). A number of spacers (3) may be present at the attachment points of mount (1).
4.1	Unclip Vario roof "closed" limit switch (left pin) (S69) from mount (1)	When removing left mount (1).
	Install
5	Clean guide (arrow) on mount (1) with rag and then lubricate	Lubricant	*BR00.45-Z-1004-06A
6.1	Install Vario roof "closed" limit switch (left pin) (S69) to left mount (1)	When installing left mount (1).
7	Install mount (1) together with spacers (3) on crossmember above windshield	Observe installation location for spacers (3) and installation markings for mount (1).
			*BA77.33-P-1011-01A
8	Clean locking lugs (4) on front catch (5) with rag and then lubricate over entire length	Lubricant	*BR00.45-Z-1004-06A
9	Check gap between Vario roof and crossmember above windshield and adjust it required		AR77.50-P-3035V
10	Install paneling on left or right A-pillar		AR68.30-P-4050V

SOFT TOP - MECHANICAL SYSTEM

Number	Designation		Model 171
BA77.33-P-1011-01A	Nut, mount for lock to cross member above windshield	Nm	10

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1004-06A	Lubricant	A 001 989 46 51