Remove/install inside rearview mirror - AR68.40-P-0001V

MODEL 171.4 

Fig 1: Identifying Inside Rearview Mirror Components

Courtesy of MERCEDES-BENZ USA

Shown on removed carrier plate 

Fig 2: Identifying Inside Rearview Mirror Components - Shown On Removed Carrier Plate

Courtesy of MERCEDES-BENZ USA

MODIFICATION NOTES

28.7.04

Installation method modified

Stage 5

	Remove
1	Fold down right sun visor, pivot to side and unscrew screw (1)
2	Pull down paneling (2) until electrical connector (3) is accessible
3	Disconnect electrical connector (3) from overhead control panel control unit (N70)
4	Slide inside rearview mirror (A67) toward front and simultaneously pull downward until inside rearview mirror (A67) is unclipped from carrier plate (6)
	Install
5	Position inside rearview mirror (A67) with mirror base (5) on carrier plate (6).Move groove (7) on stay (arrow) to stop and arrest mirror base (5) on side of carrier plate (6) with corresponding retaining spring (8). Then arrest opposite side of mirror base (5) on carrier plate (6)	Ensure that electrical line (4) is not pinched and damaged
		Retaining springs (8) should catch audibly in carrier plate (6)
6	Pull down paneling (2) and connect electrical connector (3) to overhead control panel control module (N70)
7	Position right sun visor on paneling (2) and tighten screw (1)
8	Hook right sun visor into sun visor counter bearing and fold up.