Remove/install antenna amplifier module - AR82.62-P-8300V

MODEL 171.4 

Illustrated with removed trunk lining 

Fig 1: Identifying Antenna Amplifier Module Components - Illustrated With Removed Trunk Lining

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge
	Risk of injury  caused by fingers being jammed or pinched  when removing/installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	When moving components, ensure that no body parts or limbs are within the operating range of moving parts.
1	Positioning trunk lid to assembly position		AR88.50-P-5000-01V
			Fig 2
2	Undo trunk lining at left side in upper area and push to side until electrical connectors (1) and nuts (2) are accessible	To do this, remove clips at top left side of trunk lining and push left side of trunk lining in direction of center of trunk. Refer to: ↓
		Remove/install side paneling in trunk	AR68.30-P-4800V
3	Disconnect electrical connectors (1) from left antenna amplifier module (A2/64)
4	Push out nut (2) and remove left antenna amplifier module (A2/64)
5	Install in the reverse order

Fig 2: Identifying Support (170 589 04 63 00)

Courtesy of MERCEDES-BENZ USA