Removing and installing E-net compensator - AR82.70-P-0010R

MODEL 230.4 up to 28.1.08

- except CODE (809) Model year 2009

- with CODE (852) Complete portable CTEL pre-installation on console

- with CODE (854) MB cell phone

Fig 1: Identifying E-Net Compensator Components

Courtesy of MERCEDES-BENZ USA

MODIFICATION NOTES

19.1.06

Disconnect ground line replaced by switch off ignition

Step 2

	Remove/install
1	Remove left side paneling in trunk		AR68.30-P-4800R
2	Switch off the ignition and remove the transmitter key from the EIS control unit	On vehicles with code (889) Keyless Go, press the Keyless Go start/stop button repeatedly until the ignition is switched off. Remove the Keyless Go transmitter card or transmitter key from the vehicle and store beyond the reach of the transmitter (min. 2 m).
3	Disconnect antenna line couplings (2) and electrical connector (3) from E-net compensator (A28/3)
4	Remove bolts (1)
5	Remove E-net compensator (A28/3) from bracket (4)
6	Install in the reverse order