CAN fault detection ME-SFI - fault code description - AD07.61-P-4000-32MA

1A	Fault code ME2.7.1  (Fault code according to OBD)	P2030 CAN message from electronic selector lever module control unit (N15/5) missing or faulty (P0600)
1B	Fault code ME2.7.2  (Fault code according to OBD)	P2030 CAN message from battery control unit is faulty (U0111)
2	Fault storage	After expiry of test duration and fault
	Actuation of the indicator lamp
	Engine diagnosis (EURO4)	no actuation
	CHECK ENGINE (MIL)	ME2.7.1:  Following two successive driving cycles with faults ME2.7.2:  No actuation
3	Checking frequency	Continuous
4	Checked signal or status	ME2.7.1:  The selection lever position is detected by the electronic selector lever module control unit (N15/5) at the center shifter console and transmitted via the CAN to the ETC [EGS] control unit (N15/3). This communication is monitored.
	Checking duration	Approx. 10 seconds
5		Also read out fault memory for control unit.