Position trunk lid to assembly position - AR88.50-P-5000-01R

The trunk lid can be adjusted to the assembly position when the Vario roof is closed or open.

Fig 1: Identifying Vario Roof Open Position

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Adjust trunk lid manually to assembly position: 

1. Open trunk lid.
2. Unclip covers above lock and unlock screws (1) from side luggage compartment lining (2).

   Previously move open Vario roof to load assist position.

3. Turn lock and unlock screws (1) counterclockwise as far as the stop.

   Tubular frame locks are unlocked.

   Fig 2: Identifying Side Luggage Compartment Lining And Lock And Unlock Screws

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
4. Raise tubular frame (3) at rear with aid of helper. Support trunk lid by hand
   Fig 3: Identifying Tubular Frame

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
5. Support trunk lid with a suitable object, e.g. an adjustable support brace.

   Do not put trunk lid under load in wing position to prevent damaging tubular frame and trunk lid hinge.

   Fig 4: Supporting Trunk Lid Using Adjustable Support Brace

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

   Move trunk lid to assembly position with Vario roof switch: 

6. Actuate Vario roof switch until the trunk lid is fully upright as shown in the diagram.
7. Unlock trunk lid lock and move the trunk lid to the assembly position.
   Fig 5: Identifying Trunk Lid In Fully Upright Position

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
8. Support trunk lid with a suitable object, e.g. an adjustable support brace.

   Do not put trunk lid under load in wing position to prevent damaging tubular frame and trunk lid hinge.

9. Return trunk lid to normal position in the reverse sequence.
   Fig 6: Supporting Trunk Lid Using Adjustable Support Brace

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.