Set up/dismantle side portal bracket set - AR60.20-P-1700R: Notes

MODEL 230 

Shown on A and B-pillar 

Shown on lift support points specific to convertible cars 

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the and position the four support plates below the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Set up module members on straightening bench	According to the setup plans of Celette or Car-Bench
2	Set up straightening bench with straightening bracket set	Observe the setup plans enclosed in straightening bracket set!
		Celette straightening bracket set	*WE58.40-Z-1037-01A
		Car-Bench straightening bracket set	*WE58.40-Z-1038-01A
3	Place vehicle on straightening bench using two-post lift	Align vehicle exactly with check bores and fasten securely to straightening bracket set
		Two-post lift	*WE58.40-Z-1001-05A
4	Attach vehicle to straightening bench
5	Set up portal bracket set
	The side portal can only be used in combination with a straightening system approved by MB and the associated straightening bracket set
		A and B-pillars Celette straightening system	AR60.20-P-1700-05RA
		A and B-pillars Car-Bench straightening system	AR60.20-P-1700-05RB
		Lift support points specific to convertible cars Celette straightening system	AR60.20-P-1700-07RA
		Observe tightening pattern for retaining bolts of portal frame. Refer to ↓
		Tightening pattern for mounting screws of portal frame	AR60.20-P-1700-08KA
		Lift support points specific to convertible cars Car-Bench straightening system	AR60.20-P-1700-07RB
		Observe tightening pattern for retaining bolts of portal frame. Refer to ↓
		Tightening pattern for mounting screws of portal frame	AR60.20-P-1700-08KA
		Portal frame	Figure
		Welding device	Figure
6	Dismantle in the reverse order

WE58.40-Z-1037-01A	Celette straightening bracket set 7230.300 (model R230)
WE58.40-Z-1038-01A	Car-Bench straightening bracket set 82437 (model R230)
WE58.40-Z-1001-01E	Celette straightening bench
WE58.40-Z-1002-01E	Celette straightening unit
WE58.40-Z-1003-01E	Car-Bench straightening bench
WE58.40-Z-1004-01E	Car-Bench straightening lifting platform
WE58.40-Z-1007-01E	Celette module crossmember set 955.940
WE58.40-Z-1008-01E	Celette additional member 955.908
WE58.40-Z-1009-01E	Celette straightening bracket set 7202.300
WE58.40-Z-1010-01E	Car-Bench universal cross member set A 296
WE58.40-Z-1011-01E	Car-Bench Universal crossmember set A 296/15 (all crossmembers 1500 mm long)
WE58.40-Z-1001-05A	Two-post lifting platform