Retrofit CD changer wiring harness - AZ82.64-P-0001-01RA

Subscriber sequence after installation (must be complied with):

• Radio (A2) or  COMAND operating, display and control unit (A40/3)
• CD player with changer (A2/6)
• Radio (A2) or  COMAND operating, display and control unit (A40/3)

The data line is established in accordance with the given subscriber sequence.

Fig 1: Identifying Fiber Optic Cable Modules, CD Player With Changer And Radio

Courtesy of MERCEDES-BENZ USA

1. Insert connector for D2B wiring harness into intended connection on ring component radio (A2) or  COMAND operating, display and control unit (A40/3)

   Route fiber optic cable along present leads while observing special routing guidelines and fasten with adhesive felt.

   Fig 2: CD Player With Changer Wiring Harness Communication

   Courtesy of MERCEDES-BENZ USA
2. Route D2B wiring harness (1) to shift gate through opening on noise insulation (arrow) and below ventilation duct.
3. Route D2B wiring harness (1) on right to shift gate along present leads and fasten.
   Fig 3: Identifying D2B Wiring Harness

   Courtesy of MERCEDES-BENZ USA
4. Route CD player with changer connector (A2/6) of wiring harness D2B (1) on the center duct to the installation location of the CD player and fix in position.

   Wiring harness must be routed below control unit carrier (2) (arrow).

5. Connect connector to CD player with changer (A2/6).
   Fig 4: Identifying CD Player With Changer Connector And D2B Wiring Harness

   Courtesy of MERCEDES-BENZ USA