Remove/install tilting cone sensor - AR82.95-P-0013R

MODEL 230.### 1# with CODE (855) TELE AID 

Fig 1: Identifying Tilting Cone Sensor Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove right rear luggage box	Place luggage box to the side with lines connected.
		Models 230.467/474/475/476 up to 14.1.04	AR68.30-P-7440R
		Models 230.467/474/475/476 as of 15.1.04 230.479,	AR68.30-P-7440RA
2	Disconnect ground cables at both batteries	First disconnect the on-board electrical system battery in the trunk and then the starter battery in the engine compartment.	AR54.10-P-0003R
3	Unscrew bolt (1)
4	Place bracket (3) aside	Do not overstretch electrical lines.
5	Disconnect electrical connector from tilting cone sensor (B66)
6	Unscrew bolts (2) and remove tilting cone sensor (B66)
7	Install in the reverse order