Remove/install rear axle level sensor - AR82.10-P-0005R
MODEL 230.4
Shown on vehicle with code (487) Active Body Control (ABC)
| Remove/install | |||
|---|---|---|---|
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Raise vehicle with vehicle lift | Figure | |
| 2 | Unclip and remove cover (3) | On vehicles up to 28.2.06 |
|
| 3 | Disconnect electrical connector from left rear level sensor (B22/7) or from right rear level sensor (B22/10) | ||
| 4 | Undo nut (1) for link rod from spring control arm | ||
| 5 | Undo nuts (2) from rear axle carrier and remove left rear level sensor (B22/7) or right rear level sensor (B22/10) | ||
| 6 | Undo screws for left rear level sensor (B22/7) or right rear level sensor (B22/10) from retaining plate | ||
| 7 | Install in the reverse order | ||
| 8 | Calibrate vehicle level (level calibration) | After replacing the left rear level sensor (B22/7) or right rear level sensor (B22/10). | |
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| STAR DIAGNOSIS system | *WH58.30-Z-1048-13A |
REAR AXLE LEVEL SENSOR
| Number | Designation | Model 230 with code 487 | |
|---|---|---|---|
| BA82.10-P-1003-02A | Bolt, level sensor to retaining plate | Nm | 4 |
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation | |
|---|---|---|
| WH58.30-Z-1048-13A | STAR DIAGNOSIS system, Compact Passenger Car | 6511 1801 00 |