Remove/install media interface control unit - AR82.60-P-1030R

MODEL 230.4 with CODE (518) Media interface 

Fig 1: Removing/Installing Media Interface Control Unit

Courtesy of MERCEDES-BENZ USA

	Remove/Install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Remove cover (1) on center console		AR68.20-P-2350RA
2	Remove bolts (2, arrow)
3	Unplug fiber optic cable connector (3)	To avoid damaging them, do not kink fiber optic cables, route over sharp edges or bend in radii smaller than 25 mm.
4	Cover fiber optic cable connector (3) and equipment connector at media interface control unit (N125/1).		AR82.95-P-0005-01A
5	Disconnect electrical connectors (4) and remove media interface control unit (N125/1) from center console
6	Install in the reverse order