Remove/install bulbs of headlamp unit - AR82.10-P-1201R
MODEL 230.4## ## as of 041865 up to 28.1.08 except CODE (809) Model year 2009
low beams and turn signal lights
| Remove/install | |||
|---|---|---|---|
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/risk of fire due to highly flammable materials in the area of damaged xenon bulbs Risk of injury from UV light, hot components at xenon headlamps and glass splinters when xenon bulbs crack Risk of poisoning from inhaling mercury vapors and from swallowing/skin contact with poisonous salts and mercury compounds |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulating safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure the work area is adequately ventilated. | AS82.10-Z-0001-01A | |
| 1 | Detach right front lamp unit (E2) and pull out towards the front until the lamp bracket (13) and the cover (14) are accessible | When removing right low beam (E2e2) or right turn signal light (E2e5). | AR82.10-P-4730R |
| 2 | Turn bulb socket (13) to left and remove | ||
| 3 | Pull left turn signal light (E1e5) or right turn signal light (E2e5) out of lamp bracket (13) | ||
| 4 | Unlock housing cover (14) (arrow) and remove | ||
| 5 | Turn xenon headlamp ignition module plug (15) to the left and remove | ||
| 6 | Turn retaining collar (16) to the left and remove together with left low beam (E1e2) or right low beam (E2e2) | ||
| 7 | Install in the reverse order |