Removing and installing backrest release - AR91.10-P-1460N

MODEL 215 

Fig 1: Identifying Backrest Release Remove/Install Components - Model 215 (1 Of 2)

Fig 2: Identifying Backrest Release Remove/Install Components - Model 215 (2 Of 2)

	Removal, installation
1	Remove bottom paneling		AR91.10-P-1200N
2	Press paneling (1) out with assembly wedge (2) in direction of arrow	When removing replace damaged paneling
3	Unscrew screw (5) from belt end fitting (4)		*BA91.40-P-1001-01A
4	Pull belt with belt buckle striker eye (3) and belt end fitting (4) through paneling (1) (see arrows)	Press belt passage on paneling (1) open slightly
5	Press out retainer (6) in direction of arrow and unhook control cable (7) from lever (8) downward	Observe installation direction
6	Unhook control cable (7) at top of backrest release handle (2)	Observe installation direction
7	Unscrew screws (9, 2 each) and screws (10, 2 each) from backrest release handle (2)		*BA91.10-P-1006-01C
8	Remove backrest release
9	Install in opposite order

SEATBELT/EMERGENCY TENSIONING RETRACTOR

Number	Designation		Model 215
BA91.40-P-1001-01A	Screw on belt end fitting	Nm	35

FRONT SEATS

Number	Designation	Model 215
BA91.10-P-1006-01C	Screw for backrest release housing on backrest frame	2,5