Remove, install motor-and-pump assembly pressure reservoir - AR42.10-P-0304MB

MODEL 220.175 /178 with CODE (Z07) Top protection 

Fig 1: Identifying Motor-And-Pump Assembly And Pressure Reservoir

	Remove/install
1	Remove motor-and-pump assembly (1)		AR42.10-P-0303MB
2	Unscrew pressure reservoir (2).	Installation:  lubricate pre-mounted sealing ring (arrow) with brake fluid. Screw in pressure reservoir by hand then tighten.
			*BA42.50-P-1006-01B
3	Install in the reverse order

BRAKE SYSTEM HYDRAULICS

Number	Designation		Model 220 with code Z07
BA42.50-P-1006-01B	Motor-and-pump assembly pressure reservoir	Nm	40