Retrofitting seat ventilation switch unit - AN91.29-P-1000-01M

Models 215, 220 

Fig 1: Identifying Assembly wedge (110 589 03 59 00)

Shown on model 220 

1. Use assembly wedge (4) to press trim strip (1) out of door control module trim panel (2). On model 215 remove door control module trim panel.
   Fig 2: Identifying Assembly Wedge, Trim Strip And Door Control Module Trim Panel

   

   Shown on model 220

2. Take door handle surround (3) off door handle, remove screws (5, 4 in total) and use assembly wedge (4) to press door control module trim (2) off door lining.
3. Unclip door control module trim (2) from left, right front door control module (N69/1, N69/2).

   Use a suitable tool to compress clips attaching front left/right door control module (N69/1, N69/2) and at the same time press front left/right door control module (N69/1, N69/2) out of door control module trim.

   Fig 3: Identifying Door Handle Surround, Assembly Wedge And Door Control Module Trim

   
4. Unplug switch for seat heater (N69/1s10, N69/1s11) from front left/right door control module (N69/1, N69/2) and replace with switch for seat ventilation (N69/1s13, N69/2s13).
   Fig 4: Identifying Switch For Seat Heater