Pressing out and attaching follower joint at steering knuckle - AR33.20-P-0500-01N

MODIFICATION NOTES

11.12.06	Self-locking nut, upper wishbone follower joint to steering knuckle	Model 211	*BA33.20-P-1018-01A
11.12.06	Self-locking nut, upper wishbone follower joint to steering knuckle		*BA33.20-P-1007-01F

WHEEL LOCATION, HUB

Number	Designation			Model 220 with code Z07	Model 220.875/878
BA33.20-P-1007-01F	Self-locking nut, upper wishbone follower joint to steering knuckle	Stage 1	Nm	20	20
BA33.20-P-1007-01F		Stage 2	∠°	90	90

WHEEL LOCATION, HUB

Number	Designation			Model 211 except 211.08/09/28/29	Model 215	Model 220 except 220.08/18
BA33.20-P-1018-01A	Self-locking nut, upper wishbone follower joint to steering knuckle	Stage 1	Nm	20	20	20
BA33.20-P-1018-01A		Stage 2	∠°	90	90	90

WHEEL LOCATION, HUB

Number	Designation			Model 220.08/18	Model 230
BA33.20-P-1018-01A	Self-locking nut, upper wishbone follower joint to steering knuckle	Stage 1	Nm	20	20
BA33.20-P-1018-01A		Stage 2	∠°	90	90

Fig 1: Identifying Thrust Washer M 10x1.5 (210 589 04 63 00)

Fig 2: Identifying Puller (202 589 02 33 00)

Pushing off

Unscrew self-locking nut from follower joint (8).
Screw the thrust washer (043a) onto the support joint (8).
Press off the follower joint (8) with the puller (043).
Do not damage boot, otherwise the follower joint has to be replaced.
Remove puller (043) and thrust piece (043a).

Fig 3: Identifying Follower Joint, Puller And Thrust Piece

Attaching
Clean tapered connection.
There must be no grease or oil on the taper and thread in order to guarantee a faultless connection.
Replace self-locking nut and tighten .