Remove/install front door power window switch group - AR72.29-P-0110M

MODEL 220 

Fig 1: Identifying Front Door Power Window Switch Group Remove/Install Components

	Remove, Install
1	Press molding strip (1) out of door control module cover (2) on driver's door with assembly wedge (6)		Figure
2	Remove door handle cover (3) from door handle in direction of arrow
3	Unscrew door control module cover (2) from door liner (4) of driver's door and press off with assembly wedge (6)		AR72.10-P-1000M
			Figure
4	Unclip switch group cover (5) with switch group for power window, driver's side (S20/1) from door liner	For this purpose slightly press cover in at bottom edge (arrow) and lift until cover can be removed together with switch group for power window, driver's side (S20/1)
5	Remove power window switch group connector, driver's side from door control module
6	Remove switch group cover (5) from power window switch group, driver's side (S20/1)	For this purpose press retaining lugs (arrows) for power window switch group, driver's side (S20/1) together with suitable tool until power window switch group, driver's side (S20/1) can be removed out of switch group cover (5) toward inside Power window switch group, driver's side (S20/1) can only be replaced completely
7	Install in the reverse order

Fig 2: Identifying Assembly Wedge (110 589 03 59 00)