Pressing out and attaching supporting joint at steering knuckle - AR33.20-P-0440-01I

Fig 1: Identifying Removal And Installation Tool (220 589 03 43 00)

Fig 2: Identifying Press (202 589 04 43 10)

Fig 3: Identifying Thrust Bolt (202 589 04 43 11)

Pry off supporting joint 

1. Place and tighten the stub axle with wheel hub in a vice (use protective jaw plates).
2. Remove cable holder from stub axle (arrow).

   Shown on steering knuckle on model 220 

   Fig 4: Locating Cable Holder

   
3. Press the support joint (7) from the stub axle with the puller (044) , the press (044e) , and the thrust washer (044c).
   Fig 5: Pressing Support Joint From Stub Axle With Puller

   

   Attach supporting joint 

4. Clean supporting joint (7) and mounting bore in steering knuckle.
5. Press in the supporting joint (7) with the press (44e) and the thrust washer (044d), continuing until it seats in the stub axle
   Fig 6: Pressing Supporting Joint With Press And Thrust Washer