 |
Removing |
|
|
| 1 |
Remove air filter housing |
|
|
| |
|
Models 215.374, 220.074/174 |
AR09.10-P-1150SVK |
| 2 |
Unplug connector (arrow) from suction restrictor valve |
|
|
| 3 |
Clamp off feed line (30f) from expansion reservoir of power steering pump using clamping device (08) |
Clamping device |
Figure |
| 4 |
Detach feed line (30f) from power steering pump. |
|
|
| 5 |
Unscrew high-pressure expansion hose (30i) from power steering pump. |
|
|
| 6 |
Mount connection fitting (040a) to high pressure expansion hose (30i). |
Connection, part 11 |
Figure |
| 7 |
Mount connecting hose (040b) to power steering pump |
Connecting hose, part 01 |
Figure |
| 8 |
Connect tester (039) between connecting fitting (040a) and connecting hose (040b) |
Tester |
Figure |
| 9 |
Mount feed line (30f) to power steering pump and remove clamp (08). |
|
|
| 10 |
Connect plug (arrow) to suction restrictor valve |
|
|
| 11 |
Check the steering gear oil level and correct if necessary |
|
|
 |
Check power steering oil level and correct |
|
AP46.00-P-4611N |
 |
Risk of accident from vehicle starting off by itself when engine running. Risk of injury from bruises and burns if you hold your hand into engine when it is started or when it is running. |
Secure vehicle to prevent it moving off. Wear closed and close-fitting work clothes. Do not grasp hot or rotating parts. |
AS00.00-Z-0005-01A |
| 12 |
Start engine |
|
|
| 13 |
Increase engine speed to approx. 1000 rpm |
|
|
 |
Checking |
|
|
| 14 |
Close throttle cock (039a) and check maximum operating pressure. |
Perform the test quickly to prevent the oil temperature from rising too high. |
*BE46.30-P-1001-01B |
| 15 |
Turn off engine |
|
|
| 16 |
Clamp off feed line (30f) with clamp (08) and detach from power steering pump. |
Clamping device |
Figure |
| 17 |
Unplug connector (arrow) from suction restrictor valve |
|
|
| 18 |
Disconnect tester (039) |
|
|
| 19 |
Detach connecting fitting (040a) and connecting hose (040b). |
|
|
 |
Install |
|
|
| 20 |
Replace seal rings in high-pressure expansion hose (30i). |
|
|
| 21 |
Screw high-pressure expansion hose (30i) onto power steering pump |
 |
*BA46.30-P-1003-01C |
| 22 |
Mount feed line (30f) to power steering pump and remove clamp (08). |
|
|
| 23 |
Connect plug (arrow) to suction restrictor valve |
|
|
| 24 |
Fill power steering pump and bleed |
|
AR46.30-P-0010N |
| 25 |
Inspect power-steering pump for leaks |
Visual inspection |
|
| 26 |
Install air filter housing |
|
|
| |
|
Model 215.374, 220.074/174 |
AR09.10-P-1150SVK |